2678
0

Recent articles

25.09.2020
General Meeting of the VDMA Software and Digitisation on 8 October 2020, 10:30 to 13:00, online event
25.09.2020
The bridging assistance will continue in the months September to December. In the case of Bridge II, the conditions of access will be lowered and the support extended.
25.09.2020
New provisions have been in force since 13 April. Tests after arrival remain mandatory.
25.09.2020
A web seminar series of the Erik Menges Foundation in the VDMA
25.09.2020
In practice, export financing - supported by state Hermes cover - is often requested by customers at short notice and then "good advice is expensive". Members benefit from the experience of the VDMA and the bank-independent expert knowledge.
66
0

Publications

Guidelines for the identification of positive and the exclusion of false positive and false negative findings in microbiological evaluation procedures.
Das durch das Bundesministerium für Wirtschaft und Energie (BMWi) geförderte Projekt „Interoperable Interfaces for Intelligent Production“, kurz II4IP, zielt auf die Entwicklung branchenübergreifender OPC-UA-Standards.
Die VDMA Fachverbandsschrift Nahrungsmittelmaschinen und Verpackungsmaschinen Nr. 17 (2020) gibt Hinweise zur Durchführung und Auswertung mikrobiologischer Auswertungsverfahren, die z.B. bei Steril- und Standtests im Zuge der Inbetriebnahme von hygienischen Abfüllmaschinen der VDMA, Hygieneklassen IV und V zur Anwendung kommen.
1
1

Events

No results found

78
0

Recent videos

18.09.2020
Maschinenbau und Startups arbeiten immer häufiger zusammen – und dies mit Erfolg: Drei von fünf Startup-Kooperationen im Maschinenbau sind nachhaltig gelungen,
15.09.2020
08.09.2020
The mechanical and plant engineering industry is fighting against the consequences of the global corona pandemic, but also against protectionism in international trade, which continues to be a burden - and consequently expects production to fall by 17 percent in 2020.
03.09.2020
In part 4 Florian Schlund and Jonathan Krauß explain how they integrate the new additive manufacturing technology LMD at the Franconian precision parts manufacturer toolcraft and talk about the advantages of their employer.